- A minimal ready-to-run system, integrates clock circuit, USB power management, USB connector, etc.
- Onboard 64M Bit SDRAM
- All the I/O ports are accessible on the pin headers
- JTAG/SWD programming/debugging interface
- 2.0mm header pitch, allowed to be plugged-in your application board
</figure>
Board features:
STM32F746IGT6: the high-performance STM32 MCU:
- Core: Cortex-M7 32-bit RISC + FPU + Chrom-ART graphic accelerator
- Feature: single-cycle DSP instructions
- Operating Frequency: 216MHz, 462 DMIPS/2.14 DMIPS/MHz
- Operating Voltage: 1.7V-3.6V
- Package: LQFP176
- Memories: 1024kB Flash, 320+16+4kB SRAM
- MCU communication Interfaces:
- 6 x SPI, 4 x USART, 4 x UART, 3 x I2S, 4 x I2C
- 2 x CAN, 1 x QUAD-SPI, 1 x DCMI, 2 x SAI
- 1 x FMC, 1 x SDMMC, 14 x TIM , 1xLPTIM
- 1 xLCD-TFT, 1xSPDIFRX, 1xHDMI-CEC
- 1 x USB 2.0 OTG FS
- 1 x USB 2.0 OTG HS (supports external HS PHY through ULPI)
- 1 x 10/100 Ethernet MAC
- AD & DA converters: 3 x AD (12-bit); 2 x DA (12-bit)
- Debugging/Programming: supports JTAG/SWD interfaces, supports IAP
IC42S16400J / IS42S16400J: SDRAM 1 Meg Bits x 16 Bits x 4 Banks (64-MBIT)
MIC2075: onboard USB power management device
AMS1117-3.3: 3.3V voltage regulator
8M crystal
32.768K crystal, for internal RTC with calibration
Reset button
VBUS LED
Power indicator
Power supply switch, powered from 5Vin or USB connection
Boot mode selection, for configuring BOOT0 pin
JTAG/SWD interface: for debugging/programming
USB connector, supports Device and/or Host
MCU pins expander, VCC, GND and all the I/O pins are accessible on expansion connectors for further expansion
Power jumper
- VBAT: short the jumper to use system power supply, open it to connect external power, such as battery
- VREF: short the jumper to connect VREF+ to VCC, open it to connect VREF+ to other custom pin via jumper wire
OTG jumper
- short the jumper when using USB OTG/HOST
- open the jumper to disconnect from related I/O port